Average Reviews:
(More customer reviews)This hitch was my secound Curt hitch.
First one was for a 2006 Chevy hhr. Very eazy to install.
The other hitch was for my 20011 Chevy Corbalt.
Not as eazy to installas the hhr hitch but If I knew what know now this hitch would also be very eazy to install.
I removed the trunh pan cover, spare tire & set the battery back away from where I would be drilling.
The rear dam was held by rubber/plactic fasteners, these & trime off so the the dam would come off.
Next I centered the hitch to the the bumper beam.
When I moved the hitch position then I could not see where I had marked the center so, I then used the liesence holder center as a reference. This worked ok.
It was hard to drill the 4 upper bolt holes as this beam is made of two thicknesses. A step drill might work good.
The bolts drop down from the top & I taped them on to the spacers as it is hard to reach these bolts with your fingers. I plan to use some sealer on the inside of the trunk & bolts & washers where I removed the dam.
Click Here to see more reviews about: Curt Manufacturing 11430 Class I Receiver
Get 38% OFF
Click here for more information about Curt Manufacturing 11430 Class I Receiver
No comments:
Post a Comment